![\"\"](\"https:\/\/taf.gozzled.com\/wp-content\/uploads\/2011\/10\/IMG_2476.jpg\" "\\"IMG_2476\\"")
<\/a>Damaged SOL hole ready for perspective and size correction<\/p><\/div>\n
<\/a>Masked off damaged area<\/p><\/div>\n
Next step was to fill the damage out with “PC Lumber” and sand it down:<\/p>\n
<\/a>Damaged area filled with "PC Lumber"<\/p><\/div>\n
<\/a>SOL hole with damage repaired<\/p><\/div>\n
Having finished repairing the damage (not only to the SOL hole, but also the entire playfield) I took the playfield to a local automotive paint shop and got the playfield professionally sprayed with clearcoat and sanded down flat. The results were perfect and just the right platform to start with my paint repairs.<\/p>\n
Firstly I had to generate the vector masks for each of the six colours around the SOL hole (black, fluorescent green, white, yellow, light grey and dark grey). Unfortunately with the damage to my SOL hole there was no way of knowing how the original lines had been drawn. My solution was to find a picture of an undamaged SOL hole and superimpose it onto my perspective corrected image, which was the correct size. Boy this was difficult and time consuming, but I got there! From this “master” I was then able to generate masks for each of the colours:<\/p>\n
<\/a>Sanded down damaged area - preparation for vector mask generation<\/p><\/div>\n
<\/a>A nice new reproduction playfield<\/p><\/div>\n
<\/a>Black, green, white and dark grey masks<\/p><\/div>\n
Having generated the masks, I commenced with the spray painting of each of the colours, bearing in mind, the fluorescent green would require a white background.<\/p>\n
Firstly it was laying down the “wood” colour:<\/p>\n
<\/a>All areas masked off for painting apart from the damaged wood areas<\/p><\/div>\n
<\/a>Wood colour applied<\/p><\/div>\n
Next came the greys, yellow and white:<\/p>\n
<\/a>Light and dark greys, white and yellow applied<\/p><\/div>\n
As always, matching the colours was a pain. I used the yellow I had from my TAF and white wasn’t a problem, but the greys were near on impossible. Using a light grey from my TAF and adding white, black, red and green, I was able to get close to both colours – more by luck than by judgement!<\/p>\n
As a test, I next printed the black outline onto a transparency foil and laid that over my work, to check to make sure everything was aligned correctly. I’m glad I did this, becuase sure enough, once I had laid the foil down, I found an error in the yellow\/white border. Two new masks and a bit of additional spraying later, I got it sorted out. Phew!<\/p>\n
<\/a>Black line test, showing mistake in white\/yellow border<\/p><\/div>\n
<\/a>Dark grey and yellow newly applied<\/p><\/div>\n